Workers’ hands are the most commonly injured body part. Whether the hazard comes from rotating machinery, pinches between two materials, heat, chemicals, or electricity, your hands are under constant attack. Without them, every task would be difficult to perform. This article identifies the common hazards and risks to a worker’s hands as well as ways to mitigate injuries and promote …
MCC Catastrophic Failure at a Client Facility
AES personnel were dispatched to a gas plant in northern Alberta, Canada, for emergency repair of a failed 600 v MCC bus. Before the technicians arrived, the 600 v bus components had already been disassembled by facility personnel to prepare for installation of a new MCC section. For our client, getting the facility back up and running was more critical than …
Analysis of Generator Protection Operations
This article analyzes several protection operations for large combustion turbine generators. Generator protection trips tend to be rare, so any major event is always of interest. EVENT 1: CLOSE-IN THREE-PHASE FAULT A large gas combustion turbine generator experienced a close-in three-phase fault during a rainstorm. The generator terminal voltage is rated 13.8 kV line-to-line, and the machine is high-impedance grounded. The …
Fault On Feeder M1A: Planning Recovery Using NFPA 70E
Previously, we discussed a 15 kV feeder fault at a manufacturing plant and how NFPA 70E is an important tool for the electrical worker to use in the field as they troubleshoot, repair, and restore the equipment to get the facility up and running. To recap, here’s what happened: The main circuit breaker in one of the plant’s three medium-voltage substations …
NERC and NETA
NETA has been setting standards that pave the way for the minimum requirements to ensure an electrical system operates reliably and safely since 1972. As a result of several widespread blackouts compromising the electric grid, the North American Electric Reliability Council (NERC)was appointed in 2006 by the Federal Energy Regulatory Commission (FERC) to develop various standards to aid in the …
Grounding and Bonding Meter Sockets
In an actual reported case, a severe storm blew down a large tree that struck a residence. A meter that should have been reporting 240 V reported a phase-phase voltage of 124 V. The falling tree had pulled down the service, which had then been re-attached by a service crew. A routine voltmeter check revealed 118 V between the left hot leg and neutral, …
The Life and History of James (Jim) R. White
Jim White’s prolific career in the electrical field expanded across many decades with a particular focus on training, education, and safety. Jim was Vice President of Training Services at Shermco Industries, a NFPA Certified Electrical Safety Compliance Professional, a NETA Level 4 Senior Technician, and a dedicated and well-respected professional. Jim’s contribution to the electrical industry was immeasurable, and he …